Vancare C450, Техническое руководство

Страница: 20 / 50

E
4
- Repair/Replace Charger and End Stop
IMPORTANT NOTE: There are no serviceable parts in the C-450/C-625 charger. Use extreme
caution when performing internal servicing on the lift. Ensure that the charger has been
disconnected from the power supply before starting.
REPAIR Charger End Stop
1. The C-450/C-625 charger end stop consists of the end stop components and the charging
spring clips. If it has been determined that the lift is no longer charging because there is poor
contact with the charge strips, an adjustment can be made.
2. Remove the charger end stop from the track.
3. While holding the end stop gently pull up on the charge strips and bend to desired tension.
4. If too much tension is generated, the lift will not be able to be driven out of the charger end
stop.
Adjust the tension so that lift can be driven in and out of the charger end stop.
5. With the manual traverse C-450/C-625, there is a tendency to pull the lift into the charger
end stop at an angle. This can cause one of the charger strips to lose tension. Please
explain to client that the lift should be placed on the charger gently.
REPLACE Charger End Stop
1. Should the charger strips bend and snap, a new charger end stop needs to be installed.
Remove the old end stop and disconnect the charger wires.
2. Reconnect the charger wires to the new end stop. Match the Red wire to the POSITIVE
marker on the charger end stop.
The polarity of the RED and BLACK wires is critical.
3. Replace the end stop and tighten bolts. Adjust tension as above.
Disconnect End stop Gently bend strip Correct positioning Connector Polarity
C-450/C-625 Technical Manual 031417 Page 20