Vanair 050735, Руководство по эксплуатации и список запасных частей

Страница: 75 / 180

AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 5: OPERATION
090034-OP_r0 PAGE - 57
while welding.
5.4.1 WELDER OPERATING PROCEDURE
5.4.1.1 CC (CONSTANT CURRENT) MODE
CC (Constant Current) Mode is commonly referred to as -
Stick Welding, Arc Welding, or Shielded Metal Arc
Welding (SMAW)
1. With the motor shut off, insert the twist lock
connections of the ground clamp and the
electrode holder cables into the welder
connection ports on the control panel. For
Direct Current Electrode Positive (DCEP)
connect the electrode holder to the positive
(+) port, and the ground clamp to the
negative (–) port. For Direct Current
Electrode Negative (DCEN) connect the
System Operation Group Manual
Section
Location
Operating the Welder 5.4 page 56
Welder Operating Procedure 5.4.1 page 57
CC (Constant Current) Mode 5.4.1.1 page 57
CV (Constant Voltage) Mode - Using a
Voltage Sensing Suitcase Feeder
5.4.1.2 page 59
CV (Constant Voltage) Mode - Using a
Spool Gun
5.4.1.3 page 59
NOTE
The amps/volts display will read the set
value for five (5) seconds when the dial is
adjusted, and the actual output value five
(5) seconds after the dial has been
adjusted.
WARNING
Do not rely on the thermal overload
circuit breakers on the generator to
protect personnel, power tools, or the
generator. The thermal overload circuit
breakers on the generator require time to
overheat when the generator is operating
in an overload condition — they do not
provide instant protection against short
circuiting or overload conditions. Always
use GFCI protected extension cords and
power strips when using the generator.
TABLE 5A: MOTOR THROTTLE CONTROL FUNCTION CONDITIONS
I
Compressor Switch Generator Switch Welder Switch Motor Speed Condition Result
ON OFF OFF Motor runs at full speed (3000 RPM).
OFF OFF OFF Motor is bypassed (0 RPM), ready for
application.
ON OFF ON Welder can be activated by striking an arc, and
Motor runs at full speed (3000 RPM), ready for
application.
ON ON OFF Motor runs at full speed (3000 RPM); generator
is ready for use
II
.
ON ON ON Full speed and all items available for use.
I
Any combination of the 300 Power System output functions (compressor, generator, welder) used simultaneously at
capacity will have an adverse affect on operation.
II
Consult Appendix A, Section A.3, Wattage Requirements for Common Receptacle Units for a listing of wattage
requirements of various implements.