Vanair 050735, Руководство по эксплуатации и список запасных частей

Страница: 119 / 180

AIR IN ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 7: TROUBLESHOOTING
090034-OP_r0 PAGE - 101
7.1 GENERAL INFORMATION
The information contained in this section has been
compiled from years’ worth of information gathered
from the field. It contains symptoms and usual
causes for the most common types of problems that
may occur. All available data concerning the trouble
should be systematically analyzed before undertak-
ing any repairs or component replacement.
A visual inspection is worth performing for almost all
problems and may avoid unnecessary additional
damage to the machine. The procedures which can
be performed in the least amount of time and with the
least amount of removal or disassembly of parts,
should be performed first. Adherence to a routine
maintenance regimen will minimize the occurrence of
many common problems. Refer to
Section 6.3,
Maintenance Schedule Table for a typical mainte-
nance regimen program.
Although Vanair
®
strives to anticipate situations that
may occur during the operation life of the machine
package, the
Troubleshooting Guide may not cover
all possible situations. Be aware that additional trou-
bleshooting information may be found in other
sources such as the Engine Operator’s Manual and
the Generator Operator’s Manual. Should the situa-
tion remain unresolved after exhausting available
sources, contact the Vanair Service Department at:
Phone: 800-526-8817 (toll free)
Phone: 219-879-5100, ext. 400
Fax: 219-879-5335
NOTE
When contacting the Vanair Service
Department, please have machine serial
number on hand to quickly expedite
service. See Figures W-1 (machine) and/
or W-2 ( compressor unit) in the Warranty
Details Section for serial plate locations.
SECTION 7:
TROUBLESHOOTING
WARNING
DO NOT operate any of the Air N Arc 300
Serie’s functions if there is a known
unsafe condition. Disable the equipment
by disconnecting it from its power
source. Install a lock-out tag to identify
the equipment as inoperable to other
personnel to prevent accidental
application.
WARNING
Before starting, performing maintenance,
or replacing parts, relieve system
pressure by opening the air tank drain/
vent valve. Carefully open cap to relieve
compressor pressure.
Refer to Figure 7-1 . Open fill cap
SLOWLY (contents under pressure) to
make sure all pressure has been
relieved.
KEY DESCRIPTION
A COMPRESSOR FILL CAP (red)
B FILL CAP BLEED VENT GROOVE
C Open/crack cap slightly to allow
bleed vent to relieve pressure
Figure 7-1: Pressure Relief
A
B
C