Van Der Stahl FAS-402 Series, Руководство по эксплуатации

Страница: 30 / 68

30
FAS-402 Series Operating Instructions Ver. 4.06E
[ 0 x ] Change Move
HT xx
O
C x . x s CT xx
O
C
( The cursor flashes )
[ 0 x ] Change Move
HT xx
O
F x . x s CT xx
O
F
( The cursor flashes )
[ 01 ] SEALING ONLY
Change(number)
Change(item)
COUNTER xxxxx
MENU / / MENU=Back
1 Entry 2 Change
3 Delete 4 Maintain
[ 0 x ] METHOD Select
1 SEAL 2 VAC&SEAL
2 The cursor flushes at
“HT”
.
When the cursor is in this position, press
either
or button to increase or
decrease the set value.
Pushing once will increase/decrease the value
in one increment.
If you hold the button in, the numeric value will
increase/decrease continuously. Use this method
when making wide range changes in the settings.
[Setting range: 60 ~ 250
O
C/ 140 ~ 480
O
F]
-> Skip to procedure
2
Ŷ Change the temperature of other than
currently displayed operation patterns:
Refer to "8-4-2 Select a desired operation
number.” After selecting the desired
operation number, push the
button and
proceed to 2 .
2 Ŷ
Enter(register) a new operation pattern:
Place the cursor on "1 Entry" using ,
buttons. Push button.
Skip to the operation procedure
3
.
Ŷ Change the registered operation
pattern:
Place the cursor on "2 Change" using ,
buttons. Push buttons.
Select the desired number you would like to
change the parameters using the
,
buttons and push to select.
4 Place the cursor on either
“1 SEALING ONLY”
or “2 VAC&SEAL”
using , buttons and
push to select.
Set the operating condition such as heating
temperature/ heating time/ cooling
temperature according to the on-screen
instruction.
3 The below screen will be displayed.
1 Push button when the display shows
one of the registered operation pattern as
below example.
(e.g. [01] SEALING ONLY)
The below menu display will be shown.
Push the button when an operation pattern
is displayed on the screen. The following will
be displayed.
8-4-4 Select / Enter / Change the sealing
method
8-4-5 Set the heating temperature
1 Ŷ
Change the temperature of currently
displayed operation pattern:
TIPS
The optimum heating temperature
varies depending on the film to be
sealed.
Set the heating temperature at
minimum required to make an
acceptable seal. Excessively high
heating temperature will damage the
consumables. This will lead to
decreased work productivity and
unnecessary power consumption.
TIPS
For how to set the “2 VAC&SEAL”,
please refer to “8-4-8 Select the
vacuum pattern.”