15
FAS-402 Series Operating Instructions Ver. 4.06E
a
e
d
c
b
For safety and efficient operation, please set the sealer
in the appropriate place as described below.
Insert the foot switch to the socket located on the side
of machine body. Turn and push the collar to lock it in
place.
The table height and angle can be adjusted by changing
the table mounting position to the angle bars that is
located in front of the machine as in the right
illustration.
1
Overlap the holes
“a” on the table side and “b”
on the angle bar side and fix the table using a
bolt. The position “b”
can be any other holes on
the angle bar at the desired height.
2
Choose the lower bolt position either
“c” or “d” on
the table side, and fix to “e”
on the angle bar side
using a bolt.
When fixed at the hole
“c”
, table has tilting
angle.
When fixed at the hole
“d”
, table is in the
horizontal position.
3
Securely fix the table with bolts and wing nuts
after adjusting the height and angle.
7 Proper use of the sealer
7-1 Secure the work place
7-2 Install the foot switch
7-3 Adjust the table height and angle
Warning
Installing the machine on an unstable or
inclined surface may cause the overturn of
the sealer. Be sure to install the machine
on a flat, horizontal surface and secure the
appropriate workbench.
Warning
Do not use the sealer on a wet floor. Do
not expose the sealer to water drops or
vapor. This may cause a failure and/or a
short circuit of the machine.
Warning
Using the machine in high humidity will
have the bad effect on machine’s
pneumatic parts. The condensation of
water from the built-in compressor will
increase, and it will shorten the life of the
dry filter.
Collar
