NOTE:
The door is secured with a locking bolt and Hex nut. To open the door use a
3mm Allen key to loosen the hex nut on the side of the door, being carefull not to
remove it completely. Ref to Figure A below. Then select a suitably sized spanner and
turn counter clockwise by approximately a quarter turn on the handle to open.
4. STOVE SET UP
Legs and lower front panel cover (See figure 1).
-
Locate the four leg securing studs into the four holes in the base of the body.
-
Locate the four legs to the underside of the casting body. There are two feet with
holes in the base. We recommend that these be placed at the rear of the stove.
-
Place the front panel cover on top of the front legs.
-
Secure the legs and front panel cover to
the underside of the casting body using
the nuts and washers supplied.
Flue collar, diverter box, flue spigot and
flue restrictor plate.
-
These should be located to the stove as
in figure 2. Do not bolt in place until fitting
the deflector. The flue restrictor is for use
where the flue draught is excessive. The
flue spigot is screwed to the cast flue
collar and clamps the flue restrictor plate
in place (See figure 2).
There may however, be certain
circumstances where fitting the restrictor
causes the fire to fail the spillage test. In
such cases the restrictor will have to be
removed. After removal conduct the
spillage check again.
Page 8
©
GDC Group Ltd. 2014
Figure 1.
INSTALLER GUIDE
Figure A.
