Valor Fires VALORFIRES 847, Инструкция для установщика и владельца, Страница: 24 / 32

3. CLEANING AND MAINTAINING THE
FIREFRONT
Important Safety.
Before undertaking maintenance always disconnect the firefront from the electricity
supply by removing the 3 pin plug and allowing the firefront to cool.
How do I Clean my firefront?
The firefront and plastic parts need only to be wiped clean with a dry soft cloth; do not
use polishes or abrasive materials. This is especially important when cleaning the
effects screen.
I have a problem with my firefront!
1. My remote control does not work.
The batteries in the remote control handset
probably need replacing - The remote control
handset uses 2 x 1.5V AAA type batteries.
For longer battery life use only alkaline
batteries. To install the batteries, slide the
cover down on the rear of the handset and
remove (See figure 5). The polarity of the
batteries is marked on the inside of the
battery compartment.
If the firefront does not respond to the remote
control handset commands, it is likely that the
batteries are faulty or require replacement.
The firefront can be operated manually as in section 1 of this guide
.
2. My firefront is switched on but there is no effect or heat.
The first thing to do is check the wall socket. To do this plug in a known working
appliance. If the appliance you have plugged in works then there is a good chance
that the problem lies with the 13 Amp fuse in the firefront plug. If either fuse or socket
is suspected, have them checked by an electrician.
3. My firefront is on but there is no heat and the heater fan has stopped.
Alternatively a cut out device is fitted to the firefront to prevent damage due to over
heating. If it operates due to an obstruction in the airflow, the firefront must be turned
off and allowed to cool for 15 minutes and the obstruction removed before restarting.
©
Baxi Heating U.K. Limited 2009.
OWNER GUIDE
Page 24
Figure 5. Battery cover removal