Valor Fires VALORFIRES 847, Инструкция для установщика и владельца, Страница: 11 / 32

If fitting the firefront onto a reflective or shiny surface such as a hearth we
recommend that this surface does not extend further than 300mm from the fixing
plane (wall). Reflective or shiny surfaces that project further than 300mm may reflect
an image of the internal light source.
Securing the Firefront.
The firefront must be secured into position to prevent it from being tipped over.
The following securing options are available:

Method A - Securing with wire.

Method B - Securing with wire using an Optional
Spacer Frame kit (See section 3 ).
If fitting the firefront onto a decorative hearth surface
such as marble or tile it is advisable to protect the
hearth surface. Do not drag the firefront as the surface
finish may be damaged.
Method A - Securing with wire.
1.
Supplied with the firefront is a spacer frame. The
opening for the Boiler Control should be on the right
hand side when fitting.
2.
Secure the spacer frame to the firefront using four
No.8 x 3/8 screws supplied (See figures 8 and 3).
3.
Insert the Boiler Control lead through the opening in
the spacer frame, then ensuring that the display is at
the top, gently push the Boiler Control into place. The
control will ‘click’ into place. Place the firefront in front
of the boiler, connect the Boiler Control lead to the
lead on the boiler and check the boiler operation.
INSTALLER GUIDE
Page 11
©
Baxi Heating U.K. Limited 2009.
Figure 4. Fitting the spacer
frame to the firefront
Figure 5. Fitting the Boiler
Control.