Valor Fires VALORFIRES 847, Инструкция для установщика и владельца, Страница: 12 / 32

4.
Regalia and Dream models only.
There is a supply cable slot on both sides of the
spacer frame. It is located at the base. Decide
which side to pass the supply cable through.
The nylon grommet supplied has a slot along its
length. Fit the grommet to the mains cable with
the flange edge positioned away from the fire
(See figure 6). Slide the nylon grommet along
the supply cable towards the heater. When the
grommet reaches the slot, push it into the slot
up to its flange (See figure 6).
4.
Classica and Innova models only.
Position the supply cable in the spacer frame
slot.
5.
Supplied with the firefront is a steel wire. This will be used to secure the firefront to
the top of the boiler.
6.
At the top of the firefront there
are four small holes, two each
side of the firefront. From the
front of the firefront, thread
about 50mm of the steel wire
into the outside small hole on
the right side of the firefront
(See point 1 - figure 7).
7.
Thread the other end of the
wire through the remaining small
hole to the left. Continue to push
the wire through this hole until
there is only a small loop of wire
at the front of the firefront (See
point 2 - figure 7).
8.
At the back of the firefront
there will be a long piece and a
short piece of wire coming
through the two holes. Hold the
short piece and give the long
piece a gentle tug. This will
secure the steel wire. Take the long piece and thread this through the bracket located
at the top centre of the boiler (See figure 7).
9.
From the back of the firefront thread the long piece of steel wire through the inner
small hole on the left hand side of the firefront (See figure 7).
10.
Locate the firefront in the fireplace opening, then from the front of the firefront,
gently pull the steel wire on the right hand side to gather up the excess until the
INSTALLER GUIDE
Page 12
©
Baxi Heating U.K. Limited 2009.
Figure 7. Wire fix
Figure 6. Bracket positions