rev. 3 – 26/05/2008
4/10
INSTALLATION
Installation, assembly and troubleshooting must only be performed by skilled personnel strictly in accordance
with the following instructions :
-
Remove the machine from the packing and throw away the protection pieces.
-
Remove the protection film from the equipment and the strap from the cover.
-
Set the machine perfectly straight by adjusting the supporting feet until the correct position
has been reached. A wrong alignment of the machine could affect the performance during
running.
-
For the installation of the machine an omnipolar switch must be mounted between the power
network and the equipment and it must have a minimum contact distance of at least 3mm
per pole. Allow easy access to the switch.
-
The rating plate is on the rear of the machine. From the plate can be checked if the
equipment is set to run with the available line voltage. Check that the available power
voltage matches the one printed on the rating plate.
-
During running of the machine the voltage must be /- 10% of the correct rating.
-
Earthing the equipment is mandatory in order to avoid damaging the electronic board.
-
It is strictly mandatory to comply with the fire regulations!
DIRECTIONS
Set the machine perfectly straight by adjusting the supporting feet until the correct position has been
reached. A wrong alignment of the machine could affect the performance during running.
ATTENTION : To avoid spilling oil from the pump which could damage the equipment never turn the machine
upside down or incline it. (only for the CVE 420-OLIO model).
THE EQUIPMENT MUST BE PLACED IN A WORKING ENVIRONMENT WITH AN AMBIENT
TEMPERATURE NOT LESS THAN 12°C.
Please note : do not set a higher sealing time than needed, otherwise the sealing bar and relative
teflon will burn.
For model CVE 300-SECCO only use embossed bags and no folding bags.
LEGAL REGULATIONS, TECHNICAL RULES AND DIRECTIVES
During the installation the following rules and regulations must to be observed :
-
Legal regulations in force (to be defined Country by Country)
-
Accident protection requirements and laws in force (to be defined Country by
Country).
ELECTRICAL CONNECTION
See enclosed wiring diagrams.
Check the power supply and voltage with the rating on the plate. The machine is supplied with cable and
plug.
Содержание CVE Series
Страница 2: ...rev 3 26 05 2008 2 10...