Safety 1
0020241403_02 ecoPOWER 3.0 /2, ecoPOWER 4.7 /2 Installation and maintenance instructions
3
1
Safety
1.1
Action-related warnings
Classification of action-related warnings
The action-related warnings are classified in
accordance with the severity of the possible
danger using the following warning signs and
signal words:
Warning symbols and signal words
Danger!
Imminent danger to life or risk of
severe personal injury
Danger!
Risk of death from electric shock
Warning.
Risk of minor personal injury
Caution.
Risk of material or environmental
damage
1.2
Intended use
There is a risk of injury or death to the user or
others, or of damage to the product and other
property in the event of improper use or use
for which it is not intended.
The product is intended as a heat generator
for closed heating installations and for hot
water generation.
During operation, the product generates vari-
ous emissions (heat, noise, etc.). The product
therefore has to be installed in a separate
boiler room in the building's cellar. This may
affect other installations in this boiler room
and the use of this boiler room.
Depending on the gas-fired boiler type, the
products referred to in these instructions
must only be installed and operated in con-
junction with the air/flue pipe accessories lis-
ted in the other applicable documents.
Intended use includes the following:
–
observance of accompanying operating,
installation and servicing instructions for
the product and any other system compon-
ents
–
installing and fitting the product in accord-
ance with the product and system approval
–
compliance with all inspection and main-
tenance conditions listed in the instruc-
tions.
Intended use also covers installation in ac-
cordance with the IP code.
Any other use that is not specified in these
instructions, or use beyond that specified in
this document shall be considered improper
use. Any direct commercial or industrial use
is also deemed to be improper.
Caution.
Improper use of any kind is prohibited.
1.3
General safety information
1.3.1 Risk caused by inadequate
qualifications
The following work must only be carried out
by competent persons who are sufficiently
qualified to do so:
–
Set-up
–
Dismantling
–
Installation
–
Start-up
–
Inspection and maintenance
–
Repair
–
Decommissioning
▶
Observe all instructions that are included
with the product.
▶
Proceed in accordance with current tech-
nology.
▶
Observe all applicable directives, stand-
ards, laws and other regulations.
1.3.2 Danger caused by a lack of
additional qualifications
Only a certified competent person who
has completed special training for the
ecoPOWER 3.0 / 4.7 can carry out work on
the product.
1.3.3 Informing the responsible
departments
Applicability:
Germany
There is a duty of disclosure to the respons-
ible authorities. The regulations are governed
by the regional building control. The local reg-
ulations, such as the TAB (technical connec-
