Release 1.2
23
function properly or reliably
Advanced Settings
More settings are available under the
Advanced Settings
tab. These setting s are
common to all H.323 configurations. Depending on your network requirements, please
consult your network administrator for the correct configuration.
1.
RAS Port
– This Port is used to convey the registration, admissions, bandwidth
change, and status messages between two H.323 endpoints. If not specified, the
port address is assigned automatically.
2.
Q.931 Port
– This port is used for call signaling to convey Call Setup and
teardown messages between two H.323 endpoints. If not specified, the port
address is assigned automatically.
3.
H.245 Port
– The H.245 requires at least 2 ports for media control protocol. It
should be specified as a port range. If not specified, the port address is assigned
automatically.
4.
Fast Start
-
Fast Start is a new method of call setup that bypasses some usual steps in
order to make it faster. In addition to the speed improvement, Fast Start allows the media
channels to be operational before the CONNECT message is sent, which is a requirement
for certain billing procedures. Leave this enabled if you are not sure.
5.
Register Mode
- Two registration modes are support.
Register Multiple
Numbers
mode means that multiple numbers are registered in a single
www.vaidsys.ru
HT-842 User Manual
