Vaderstad Rapid Series, Инструкция по эксплуатации

Страница: 17 / 48

General settings
6.3.1 External control off
External Control is switched off.
6.3.2 ISOBUS Task Control
Task Control is a GPS-based help function for use in the
field. A GPS terminal supporting this function is required
for Task Control to work correctly. Contact your local
GPS supplier to ensure that the correct functionality is
available.
Figure 6.4 ISOBUS Task Control settings
When settings are changed in Task Control, it
will restart. A counter starts and counts down
from 20 to 0 seconds. During this time, it is not
possible to change the status in Task Control.
When the countdown has finished, the specified
selection is displayed again.
This is where information is entered regarding the
geometric location of the drill in relation to the tractor
These settings are recommended settings, and
may be need to be adjusted by the operator.
A. Standard settings, set standard values for all TC
parameters on the machine
B. Type of hitch device, triple point or hitching hook
C. Compensation for any canting. If the machine is
pulling in one direction or if it is offset to one side.
Units are given in cm
D. Distance between the hitching point and ground
contact point, for example, gauge wheels. Units are
given in cm
6.3.3 Product offset
Figure 6.5
E. Displays standard settings for offset
F. Ground contact point
G. Product offset
Distance between the ground contact point and
application point.
This measurement together with the measurement in the
field for Connector Offset X (see D in
“Figure 6.4
ISOBUS Task Control settings“ ) is the same as the
distance from the hitch device to the seed coulter. Units
are given in cm.
Figure 6.6
Setting functions and delay
H. Section shut off
• Yes
• No
• Sync with Seed/Fertiliser/Biodrill
It is possible to allow multiple products to be
controlled by the same on/off signals. Products with
section control via GPS can be synchronized with
other products. i.e. if section shutdown for seed is set
to Yes and fertiliser is set to synchronise with seed,
then the section shutdown for seed will control both
seed and fertiliser.
This may be relevant if the terminal cannot handle the
current number of products on the machine.
I. Variable sown amount, Yes/No, controlled sown
amount with GPS.
903099-en-gb; 19.01.2021 13