22
Circuit for hydraulic feed output/hydraulic following harrow (red circuit).
1. Field test.
1.
Perform a calibration test and enter the sown amount to be sown (see calibration page 11).
2.
Repeat the process for fertiliser and, if relevant, BioDrill, if these are to be used.
3.
The Hydraulic following harrow also need to be activated.
4.
Start sowing at the intended speed.
5.
Now reduce the variable hydraulic flow on the red circuit slowly, until an alarm is generated for
Seed valve Max power
Fertiliser valve Max power
BioDrill valve Max power
Then increase the flow by approx. 5–10%.
You can stop movement of the above on the iPad/ISOBUS or ControlStation using adjustment of sown amount (re-
mote on the side of CS), by holding in the manual output button instead of driving in the field.
The feed output system and, if relevant, hydraulic following harrow take approx. 10–20 litres/min.
It will normally be sufficient to bring the hydraulic flow down to approx. 30%. If this is not sufficient, an alarm will
be generated for Seed Valve Max Power, in which case, increase the flow by approx. 5–10%.
17/05/2016
RD 300-400S/C
Attachment 2
Manual output iPad
Manual output Con-
trolStation
Attachment 3
Before the season
Connect the iPad to the Internet and select the E-Control app.
Select Search for updates.
iPad updates
More information can be found in the instruction book.
