This system uses a sealed HEPA type bag (Part # HPB2HD).
The mass of dirt and debris is picked up by your vacuum
and deposited into the bag inside your dirt canister.
Emptying your Dirt Can
To remove accumulation, follow these steps:
Remove the lid by unhooking the clamps & releasing
the latches on the top of the canister. (Fig. 1) Lift lid
straight up. (Fig. 2)
Remove the bag by sliding the rubber gasket that sur-
rounds the holes in the paper bag off the plastic inlet stems
that protrude through the front & side of canister. (Fig. 3)
Once the bag is off of the inlet stem, seal the bag by re-
moving the backing from the tabs and cover the holes
with the flaps. Press the flaps so that they securely seal
over the holes (Fig. 4). This will help prevent dirt and
dust from escaping. Now, lift the paper bag from the
dirt canister and place in a suitable trash container.
Take a new bag and extend it fully (Fig. 5).
1
2
3
4
5
If bag breaks...
In the event of a bag breaking while in the unit, it is necessary
to lift the protection plate located under the bag and clean the
small mesh screen as well as the notched safety screen.
The bag should be changed or cleaned when there is 3-6 inches of dirt or
anytime there is a noticeable reduction of air flow at the cleaning
HOW OFTEN SHOULD I CHECK OR EMPTY THE HEPA BAG?
?
tool. Initially, the dirt canister should be checked or emptied weekly until some
idea can be obtained as to how long it takes to half fill the canister under your
normal cleaning routine. All vacuum systems will function more effectively
if they are emptied frequently. Under no circumstances should you allow your
dirt canister to become more than 3/4 full before emptying.
5
6
MAINTENANCE
Installing a New Bag
8
4
3
2
1
1
Place bag in the canister, and slide its rubber gaskets
onto each inlet stem until the rubber gasket drops into
place in the ridge that is around the inlet stem (Fig. 6).
Do so for both inlet stems.
Carefully replace the lid onto the dirt canister to
ensure that it seals properly. Not doing so could cause
a vacuum leak and reduce the cleaning efficiency of
your system. Once properly on top, secure the lid with
the latches by hooking the clip over the side of the
lid and pushing down on the lever to lock into place.
Repeat for each side.
6
