Vacuuming
Inserting the hose
The hose connects to the system through the utility valve
inlet on the front of the unit by lifting the door open
and inserting the hose. (Fig. 1) If your system has been
plumbed for additional valves, you insert the hose into
the valve you want to use. Only one valve can be used at
a time.
USING YOUR SYSTEM
7
1
4
Install the HEPA bag onto the 2 inlet stems inside the
canister.
First, take the bag and fully expand it.
Then place it in the canister and slide each gasket onto
the inlet stems until they drop into place in the ridge that
is around the inlet stems.
Place the lid onto the dirt canister and ensure that it seals
properly.
REMINDER: This is not a wet pickup and cannot be used with liquid.
Doing so will void warranty.
If plumbed with additional valves:
Leave the on/off switch turned OFF. Each valve is wired with low
voltage and will turn on once the hose is inserted and will go off
once hose is removed.
If using utility valve on front of unit:
Insert the hose before turning the unit on. The system is turned on
and off by flipping the switch on the side of the unit.
