Vacuum cleaner won’t run
•
Be sure the unit is plugged in.
•
Be sure you turned the system on.
•
Check your circuit breaker panel.
Make sure there is not too much on
that circuit causing it to trip.
Low suction or no suction
•
First, see instructions above.
•
Usually low suction is caused by a full
bag. Change your bag. See
Operating Instructions for details.
•
Is the dirt canister lid off or loose?
Be sure the lid is replaced squarely on
the top of the canister and that the
gasket has not been pulled loose or it
could allow a vacuum leak. If gasket is
loose, reattach with contact cement
or super glue.
•
Is there blockage in the hose or tools?
Disconnect the hose from power unit,
use a blunt item to push the clog out.
If the blockage is in the tools, remove it.
•
Is Protector Plate in place?
Lift the lid. The metal plate should
be located just beneath the HEPA bag
inside the can, laying flat with the
smooth side up, prong side down.
Most problems that develop can be fixed easily by following the below suggested solutions:
TROUBLESHOOTING
10
ADDITIONAL KITS & ACCESSORIES
1.
1-1/4” Hose (30 or 50’)
2.
Hose Hanger
3.
Industrial Crevice Tool
4.
Industrial Upholstery
Tool
CKP30/CKP50 - 30 ft. or 50 ft.
Commercial Tool kit
1.
1-1/4” Hose (30 or 50’)
2.
Hose Hanger
3.
Dusting
Brush
4.
Upholstery Tool
5.
Crevice Tool
6.
Telescopic Wand
7.
Floor Brush
8.
Tool Storage Bag
GKP30/GKP50 - 30 ft. or 50 ft.
Garage Kit
MK3 - Muffler Kit
12” round muffler, 90° medium
sweep elbow, 2 street couplers
UVK1 - Utility Valve Kit
1-1/4” plastic utility valve, two
reducer couplings (2” to schedule
40), 90° sharp radius street ell
UVK3 - 3 Valve Utility Kit
Three 1-1/4” plastic utility valves, four
reducer couplings (2” to schedule 40),
& three 90° sharp radius street ell
Available at www.vacumaid.com
or on Amazon.
