6
vacon
X
5
EIP
01
Ethernet IP with
115
VAC / Encoder Interface Option Board
Next, install the flexible circuit to finish the interface to the control board. (Refer to Figure 4.) To install the flexible
circuit, first remove the keypad frame (necessary in this size unit). The frame is attached with two screws in opposite
corners; the screws thread into fasteners in the plastic assembly. After the flexible circuit is installed, replace these
screws, limiting the installation torque to 12 in-lbs..
Figure 4: Flexible Circuit Interface to Control Board
115 VAC
Interface / Relay / Encoder Interface Terminals
Figure 5: 115 VAC Interface / Encoder Terminals
The X5OPT01 option kit includes five 115 VAC inputs, two additional programmable relays, and an encoder interface.
The details of the terminals on the board related to the 115 VAC interface and the encoder are shown in
Table 1 on
page 7
:
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
