Vacmaster VK1650SWD 950091, Руководство пользователя

Страница: 6 / 13

6 7
G
ENERAL ASSEMBLY INSTRUCTIONS
WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Undo the latches. (As show in fig.2)
2. Lift the power head off the container. (fig.3)
3. Remove the contents from inside the container, make sure you have all contents as
listed on page12. (fig.4)
4. With the power head removed, turn the container upside down. Insert the two
casters into the socket on to bottom of the castor feet and tighten one castor with
4 screws.(fig.5)
5. Insert the rear wheel shaft (R) into the rear support block. Insert washer (N) on
the shaft, then insert rear wheel (L) on the shaft. Insert the ‘R’ lock pin (M) into the
hole on the end of the shaft to lock the wheel. Snap the hub cap (O) on to the
wheel. Repeat the same steps at the other end of the shaft. Please notice you must
install the hub cap on to the wheel , otherwise the ‘R’ lock pin will come loose
result in wheel do not work .(fig. 6)
6. For wet vacuum cleaning, install the supplied foam filter. (fig. 7) See page 11 for
filter installation.
7. Your vacuum comes ready for dry vacuum cleaning with PET cartridge filter pre-
installed. If cartridge filter is not installed, refer to page 16 for filter installation.
(fig.8&fig.9)The PET cartridge filter fit for wet & dry vacuum cleaning.
8. Put the PRE cloth filter over the filter tray with the attached PET cartridge filter.
(fig.10)
9. Optional, for improved dust filtering, fit collection bag flange onto the inlet stub,
taking care not to damage the bag. (fig.11)
10. Place the power head back on the container, and secure into place using the 2
side latches. (fig.12&fig.13)
11. Insert the push handle into the handle sockets mounted on the sides of the tank.
Push down until the lock pin clicks in place. (fig.14)
12. Accessory pouch is fixed on the push handle (fig.15)
13. Secure the large end of the hose into the vacuum port on the container and screw
into place. Choose the desired accessories and extension wands and push onto
the suction tube. (fig.16)
5 7 6
2 1
8
4 3
12
14 15 16
17
13
11 10 9
R N N
L
L
O
O
D
RY-VACUUM OPERATION
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN
AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE CHANGING AND CLEANING FILTERS.