8 9
2. Remove collection bag & cartridge filter, then carefully install the foam sleeve filter
over the filter cage and place the power head back on the container. (fig. 2) See
filter installing instructions on page 10.
3. Fit the desired nozzle to the vacuum hose. (fig.3)
4. Verify that the switch is in the ‘O’ OFF position before plugging the power cord
into the outlet. (fig.4)
5. Turn the motor on by flipping the switch to the ‘I’ ON position. (fig.5)
OPERATING INSTRUCTIONS – WET VACUUMING
6. Turn the vacuum off.
7. After use, empty the container by unscrewing the drain cap and drain liquids into
suitable receptacle or drain. (fig.6) Remember to refit the drain cap to the
container after draining container.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the
nozzle completely in the liquid; leave a gap at the tip of the nozzle opening
to allow air inflow. The machine is fitted with a float valve that stops the
suction action when the container reaches its maximum capacity. You will
notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or
drain. To continue vacuuming, refit the container with the drain cap. After wet
vacuuming, turn the machine off and remove plug from power supply. Empty
the container, clean and dry the inside and outside before storage.
REMEMBER!
The collection bag must be removed in wet vacuuming.
1
3
5
2
4
6
M
AINTENANCE
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE CHANGING AND CLEANING FILTERS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the vacuum, turning large end in counter clockwise
direction. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Check the hose, attachments, and power cord to verify that they have not been
damaged.
IMPORTANT!
Clean or change the cartridge filter regularly for best
performance. ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING. If the
machine is used with out the cartridge filter, the motor will burn out and the
warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filters included are made of high quality materials designed to
stop small dust particles. The cartridge filter should be used for dry pick-up
only. A dry cartridge filter is necessary to pick up dust. If the cartridge filter
is wet, it will clog quickly and be very difficult to clean. Handle the filter
carefully when removing it for cleaning and replacing it. Check the filters for
tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a filter with holes or tears, replace it immediately.
WARNING!
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM CONTAINER.
1
3
2
4
I
NSTALLING & CLEANING CARTRIDGE FILTERS
Installing Cartridge Filter
Содержание VK1650SWD 950091
Страница 13: ...VK1650SWD 950091 13 ...
