ENGLISH
RELEASE FROM OUTSIDE
Install the special accessory release kit to release the
automation from outside (cod.
J5
).
• Insert the metallic string into the special draft truck hole.
• Insert the sheath on the string and assemble the rest of
kit parts.
• Stretch the string and fasten it by means of the special
fastening screw so that the complete automation release is
enabled.
Once this kit has been installed, just turn the doorknob to
release the automation; turn the doorknob into the beginning
position before open the door.
AUTOMATION RESTARTING
To restart the automation use proceed as follows:
• Bring the
C1
unblocking lever back to the initial position.
• Activate the motor with a START input: the slider will hook
automatically the draft truck, restarting the automation.
PLACEMENT AND FASTENING OF THE
MECHANIC STOPS
m
WARNING: the correct placement and fastening of the
mechanic stops is important for the correct working of the
automation, therefore follow carefully these instructions.
1.
Release the automation and fully open the door.
2.
Position the mechanic stop
S
near the maximum opening
point of the door, then fasten tightly the two grub screws
G1
.
WARNING:
Working normally, the door will stop at about 30 mm
from the mechanic opening stop.
3.
Completely close the door and position the mechanic closing
stop
T
at 1 cm from the draft truck
C
, then fasten tightly the
two grub screws
G1
.
25
