Uwatec G2TEK, Руководство пользователя

Страница: 87 / 92

87
English
GALILEO 2 TEK (G2TEK) USER MANUAL
Operating frequency 2402-2478 MHz,
max power < 3 dBm, connection range
approx. 2m.
7 .2 Maintenance
The G2TEK’s depth accuracy should be
verified every two years by an authorized
SCUBAPRO dealer.
The tank pressure gauge and the parts of
this product used to measure tank pressure
should be serviced by an authorized
SCUBAPRO dealer every other year, or
after 200 dives (whichever comes first).
Aside from that, the G2TEK is virtually
maintenance-free. All you need to do is
rinse it carefully with fresh water after each
dive and charge the battery when needed.
To avoid possible problems with your
G2TEK, the following recommendations will
help assure years of trouble-free service:
• Avoid dropping or jarring your G2TEK.
• Do not expose your G2TEK to intense,
direct sunlight.
• Do not store your G2TEK in a sealed
container; always ensure free ventilation.
• If there are problems with the water or
USB contacts, use soapy water to clean
your G2TEK and dry it thoroughly. Do
not use silicone grease on the water
contacts!
• Do not clean your G2TEK with liquids
containing solvents.
• Check the battery capacity before each
dive.
• If the battery warning appears, charge
the battery.
• If any error message appears on the
display, take your G2TEK back to an
authorized SCUBAPRO dealer.
7 .3 Replacing the battery
in the high- pressure
transmitter
WARNING
We recommend having the battery of the
transmitter replaced by an authorized
SCUBAPRO dealer.
The change must be made with particular
care in order to prevent water from seeping
in. The warranty does not cover damages
due to improper replacement of the battery.
• Remove the transmitter from the HP
port of the first stage regulator.
• Dry the transmitter with a soft towel.
• Remove the lock ring with a pair of ring
pliers. (f)
• Slide the outer sleeve downwards. (e)
• Remove the transmitter lower and upper
O-Ring. (b & d)
• Slide the lid to the side (c)
• Remove the battery cap. (a)
• Insert new battery and new O-rings.
• Wait 30 seconds.
• Carefully slide back the lid onto the
housing. Make sure that the lid is slid
exactly up to the stop on the core part.
Check the fits of the two O-rings. Then