Uwatec G2TEK, Руководство пользователя

Страница: 60 / 92

60
GALILEO 2 TEK (G2TEK) USER MANUAL
The G2TEK will display the text SWITCH
TO GAS T1 SUCCESSFUL 4 seconds
and adapt the decompression schedule
accordingly.
Gas switch not carried out at the
planned depth
If you fail to confirm the gas change within
the 30 seconds of when the G2TEK
suggests it, the gas is excluded from
the decompression calculation and the
decompression schedule is adapted
accordingly, basically reflecting the fact that
you will finish the dive without using the
excluded gas.
Delayed gas switch
You can catch up on a planned gas mixture
switch at any time by selecting the gas
manually. Press-and-hold the BOOK button
to start the gas switch procedure. The
G2TEK will show the message
SWITCH
TO GAS T2 on the display. This helps you
verify that you are performing a switch to
a safe gas. At this point you would press
the SAVE button to confirm the switch. The
G2TEK will display the message
SWITCH
TO GAS T2 SUCCESSFUL and adapt the
decompression schedule accordingly.
Submerging below the MOD after a
gas switch
If after having switched to gas 2 you
inadvertently drop again below the MOD
for that mixture, the MOD alarm will
immediately be activated. In this case,
you would either switch back to gas 1 or
ascend above the MOD for gas 2.
Predicted decompression stops and
gas changes during ascent
The main dive display will show only the
deepest decompression stop depth and
time with TAT.
By a press-and-hold of the MORE button
the gas summary table is shown. By
pressing the MORE button, the predicted
decompression stops are shown with all
enabled gases used (PMG) and assuming
only the current gas would be used (1G).
Also, current selected GF stops as well as
GF 100/100 schedules are shown.