Hallett
30 1” Instruction Manual
Released on 1-Sep-16
– X800058R
Page 32
UV Pure Technologies Inc. © 2016
Reassembling the Unit
Note that numbers in parentheses refer to Figure 4B.
Step 1:
Replace the wiper assembly (6) carefully in the quartz sleeve. Turn the
wiper assembly clockwise (looking from the top) as it is being inserted into the
quartz
– this will make the task easier and align the wiper blades properly. The
square shaft must fit into the square cavity of the shaft adapter (6A).
Step 2:
Ensure the quartz O-ring seal (24) is in place around the quartz sleeve
and then replace the top end cap (2) by aligning the small hole in the thin plate
with the top pin of the wiper assembly (6). This will help center both parts.
Step 3:
Replace the top bracket (14) over the top end cap (17). The collar of the
end cap will fit snugly in the hole in the bracket and align itself. Tighten the
fasteners (16) in an alternating pattern (
lock washers (15) must be installed
).
Step 4:
Reconnect the wiper motor (5) to the bottom bracket (22). The flat blade
on the wiper motor shaft must be aligned with the slot in the round wiper shaft
–
the wiper shaft can be rotated counter-clockwise to accommodate this. Remove
the foam pad in order to see the motor shaft. Once this alignment is done, the
motor plate and foam pad can be placed back onto the mounting standoffs and
secured with the three nuts. The nuts are self-locking, engage them until motor
mounting plate comes to rest on the bottom Bracket (22).
Do not over tighten
.
Step 5:
Reconnect the flexible hoses (8), both top and bottom.
Figure 4D
Step 6:
Close any faucets and open the water supply. Inspect for leaks. The
solenoid valve can be placed into manual mode to allow water to enter the unit.
Switch back to automatic mode when done. Repair any leaks if necessary.
Caution:
Do not operate the unit if there are any leaks at the piping connections
or within the unit.
Step 7:
Reinstall the reflectors &/or side panels. Ensure the cover panel is
completely flat against the body of the unit before tightening the screws.
