US Robotics 56 1, Справочник по командам

Страница: 51 / 108

56K Softmodem
Command Reference
- 45
Table 3-79: +ESR Parameter Values
Table 3-80: +ESR Extended Syntax Commands
Note: * Refer to ITU- T recommendation V.42 for a complete definition of the selective reject mode.
+ETBM=<pending_TD>,<pending_RD>,<timer>—Call Termination Buffer Manage-
ment
Use this command to set the behavior of the modem during call termination. The
<pending_TD> parameter controls how previously transmitted data remaining in
the DCE buffers is handled when the DTE request a disconnect from the call. The
<pending_RD> parameter controls how previously received data remaining in the
DCE buffers is handled when the remote DCE disconnects the call. The <timer>
parameter sets the maximum amount of time the 56K Softmodem will attempt to
deliver the buffered data before abandoning the attempt and discarding any
remaining data.
Result codes:
OK if <pending_TD> = 0—2 and <pending RD> = 0—2 and <timer> = 0—254.
ERROR if <pending_TD> does not equal 0—2 or <pending RD> does not equal
0—2 or <timer> does not equal 0—254.
Command Description
0 Enables the selective reject mode.
1 Disables the selective reject mode.
Command Description
+ESR=<value> Turns on or turns off the selective reject mode.
+ESR? Displays the current settings for the selective reject mode.
+ESR=? Displays the supported settings for the selective reject mode.