US Robotics 56 1, Справочник по командам

Страница: 34 / 108

56K Softmodem
Command Reference
- 28
Table 3-36: \K<value> Commands When Modem Is Operating in Data Transfer Mode
The second case, shown in Table 3-37: \K<value> Commands When Modem Is
On-Line Command State During Data Connection, occurs when the modem is in
the on-line command state (waiting for AT commands) during a data connection,
and the
\B<value> command is received in order to send a break to the remote
modem.
Table 3-37: \K<value> Commands When Modem Is On-Line Command State During Data Connec-
tion
Finally, the third case occurs when a break is received from a remote modem
during a connection. These commands are shown in Table 3-38: \K<value>
Commands When Break Is Received During Connection .
Table 3-38: \K<value> Commands When Break Is Received During Connection
\N<error_control>—Select Error Control Mode
Use this command to select the type of error control used by the modem when
sending or receiving data. Result codes:
OK if <error_control> = 0—5, or 7.
ERROR if <error_control>
does not equal 0—5, or 7.
Command Function
\K0, \K2, K4 Enter on-line command mode. No break is sent to the remote modem.
\K1 Clears data buffers and sends a break to the remote modem.
\K3 Sends a break to the remote modem immediately.
\K5 Sends a nondestructive, nonexpedited break to the remote modem (default).
Command Function
\K0, \K1 Clears data buffers and sends a break to the remote modem.
\K2, \K3 Sends a break to the remote modem immediately.
\K4, \K5 Sends a break to the remote modem in sequence with data (default).
Command Function
\K0, \K1 Clears data buffers and sends a break to the DTE.
\K2, \K3 Sends a break to the DTE immediately.
\K4, \K5 Sends a break to the DTE in sequence with received data (default).