US Robotics 56 1, Справочник по командам

Страница: 33 / 108

56K Softmodem
Command Reference
- 27
control to the remote DCE. Result codes:
OK if <value> = 0—1.
ERROR if <value> does not equal 0—1.
Table 3-34: \G<value> Commands
\J<value>—Adjust Bits/s Rate Control
Use this command to specify whether or not the negotiated connect speed of the
modem forces the adjustment of the speed of the DTE to the modem’s speed.
Result codes:
OK if <value> = 0—1.
ERROR if <value> does not equal 0—1.
Table 3-35: \J<value> Commands
\K<value>—Set Break Control
Use this command to control the response of the modem to a break received from
the DTE, remote modem, or the
\B<value> command.
Result codes:
OK if <value> = 0—5.
ERROR if <value> does not equal
0—5.
The response is different in three separate cases. The first case is where the
modem receives a break from the DTE when it is operating in data transfer mode.
See Table 3-36: \K<value> Commands When Modem Is Operating in Data
Transfer Mode.
Command Function
\G0 The modem processes XON/XOFF flow control characters locally (default).
\G1 The modem passes XON/XOFF flow control characters.
Command Function
\J0 Buffer mode. Error control is set or disabled with the \N<value> command (default).
\J1 Forces the maximum DCE rate to the DTE rate.