Urrea CE1115, Руководство пользователя и гарантия

Страница: 38 / 44

38
3. One or both of the bed rollers are set too
low or too high. Lower/raise the bed rollers.
4. Chip breaker or pressure bar set too low.
Raise the height of the chip breaker or pres-
sure bar.
5. Feed rollers set too low or too high. Adjust
the feed rollers to the correct height.
CONSISTENT CHIPPING PATTERN.
1. Knots or conflicting grain direction in work-
piece. Inspect workpiece for knots and grain
direction; use only clean stock.
2. Nicked or chipped knife. Sharpen/replace
knife.
3. Feed rate too fast. Reduce feed rate.
4. Depth of cut too deep. Reduce the depth of
cut.
5. Misaligned chip breaker. Adjust both sides of
chip breaker to the correct height.
FUZZY GRAIN
1. Workpiece has high moisture content or
surface wetness. Sticker and allow workpiece
to dry if moisture content is over 20% or has
surface wetness.
2. Dull knives/inserts. Sharpen/replace knives.
LONG LINES OR RIDGES THAT RUN THE LENGTH
OF THE WORKPIECE
1. Nicked or chipped knife. Sharpen/replace
knives.
UNEVEN CUTTING MARKS, WAVY SURFACE,
OR CHATTER MARKS ACROSS THE FACE OF
THE WORKPIECE
1. Feed rate too fast. Reduce feed rate.
2. Chip breaker or pressure bar set unevenly.
Adjust the height of the chip breaker or pres-
sure bar.
3. One or both of the bed rollers are set too
low or too high. Lower/raise the bed rollers.
4. Knife heights not correct. Adjust knives to
the proper height.
5. Worn cutterhead bearings. Replace cutter-
head bearings.
GLOSSY SURFACE
1. Knives are dull. Sharpen/replace knives.
2. Feed rate too slow. Increase feed rate.
3. Depth of cut too shallow. Increase depth of
cut.
INCONSISTENT CHIP MARKS
1. Chips are not being properly expelled from
around the cutterhead. Use an adequate dust
collection system; adjust the chip deflector in
or out, depending upon your setup.
TECHNICAL DATA
CE1120A
VOLTAGE-FREQUENCY 220 V ~ 60 Hz
PHASES 1 ~
MAXIMUM CUTTING WIDTH 20" (508 mm)
MAXIMUM CUTTING HEIGHT 8" (203 mm)
CUTTERHEAD DIAMETER 3 1/8" (79,4 mm)
CUTTERHEAD SPEED 5 000 r/min
MOTOR SPEED 3 450 r/min
FEED RATE 16 & 20 FPM
POWER 5 HP (3 730 W)
WEIGHT 350 kg (771 lb)
CE1115
VOLTAGE-FREQUENCY 220 V ~ 60 Hz
PHASES 1 ~
MAXIMUM CUTTING WIDTH 15" (381 mm)
MAXIMUM CUTTING HEIGHT 8" (203 mm)
CUTTERHEAD DIAMETER 3" (76 mm)
CUTTERHEAD SPEED 5 000 r/min
MOTOR SPEED 3 450 r/min
FEED RATE 16 & 30 FPM
POWER 3 HP (2 237 W)
WEIGHT 270 kg (595 lb)