urmet domus Easy Dome IV 1092 Series, Инструкция по установке и эксплуатации

Страница: 76 / 116

DS1092-121 76
4 OPERATING MODE
4.1 OPERATION AT POWER-UP
The camera employs the default settings the first time it is switched on. Changes to the settings will be permanently
stored and will be made available the next time the camera is switched on. You can return to the default settings by
means of the appropriate menu option at any time.
The camera will work as follows when it is switched on.
1. The camera will run a calibration procedure and a message showing the following information will appear on the
video output OSD (On Screen Display): protocol, communication parameters, camera address and software
version.
Check that the data are suitable for operation.
Otherwise, refer to the section in this document that shows how to install the camera correctly (chapter 4.7).
PTOL: PELCO-D
COMM: 9600,N,8,1
ADDR: 01
SW version
2. At the end of the calibration step, the camera will switch to stand-by as programmed (
POWER UP ACTION
in
<FUNCTION PROGRAMMING • MOTION>
). The camera will continue working this way until any command is
received from the keypad. The camera during this phase can be pointed to a fixed point or pan across the field.
Refer to the detailed described in the
POWER UP ACTION
menu section for more details.
4.2 HOW TO USE THE CONTROL KEYPAD 1092/693 - 1092/694
The camera is ready to receive commands from the control keypads Ref. 1092/693 - 1092/694 (see figure below) after
calibration.
1092/693 control keypad
For use of the keypad, refer to the related user manual.
Joystick
Display LCD
Keypad