URC MRX-10, Руководство по установке

Страница: 5 / 11

67
Physical Installation of the MRX-10 and Accessories
The MRX-10 Advanced System Controller can be installed anywhere in the home where a Cat-5 network wire
can be installed. It can then be programmed to operate all local equipment using IR, RS-232 or Relays. It can
either be placed on top of the equipment or rack mounted (
using the optional rack-mount adapter. ) It must
receive power using the included power supply. All IR emitters, RS-232 cables and sensors are plugged into
their respective ports on the back. Wires are connected to the detachable connectors for use of the relays.
Network Installation
1. Connect an Ethernet cable ( RJ45 ) to the rear of the MRX-10 and into the network router or switch.
2. Connect your laptop into the same network router as the MRX-10.
3. Plug flashers into any of the eight flasher ports on the rear of the MRX-10.
Locating the MAC Address
The network MAC Address is a unique number that identifies a device on a network. By listing the MAC
address during programming, URC network devices can use DHCP and do not require Static IP Addresses.
The MAC address of the MRX-10 can be discovered over the network through programming. The unit’s
MAC address can be found on a label on the side of the unit (left side when facing rear).