| 9
Unpacking and Initial Setup
Pallet Bracket Removal
Use a 5/16” socket to remove the pallet brackets on both
sides of the unit. These can be discarded.
Lift Handle Assembly
The lifting handles come attached to the unit. You will
need to assemble the brackets using the bend tabs in
order to lift the unit into place. The handles have been
designed to be used with 2X4 lumber. Assemble as
follows:
1.
Cut two 2X4 no shorter than 18” (this is the
minimum distance needed to safely span both handles).
2.
Bend
support leg into position
(labelled A)
.
3.
Bend handles perpendicular to fireplace
as shown in image above
(labelled B)
4.
Use a 5/16 socket to remove lone fastener
5.
Line up the support leg hole and secure
with lone fastener (
Labelled A).
6.
Slide 2X4 through handles on each
side to create a strong lifting point.
7.
Move Unit into position. Remove
handles and discard.
A
A
B
B