18 |
Maintenance and Service
Remote Syncing
The remote should be synced to your fireplace by your
installer during installation.
Your remote may gradually lose its RF connection strength
over time. Re sync the remote if this happens or if the
batteries have been changed. Re sync remote as follows:
LOCATION OF SWITCH
PANEL
BELOW THE BOTTOM
BEZEL (LIFT OR REMOVE)
REMOTE
SYNC
BUTTON
POWER VENT
SWITCH
(INSTALLER USE
ONLY)
1.
Locate the switch tool supplied
with your fireplace (see photo).
2.
Locate the hidden switch panel
mounted on the inner fireplace
cabinet underneath the trim bezel.
3.
Use the tool to press the middle
switch. You will hear 3 beeps from the IFC.
4.
On hearing the 3 beeps, press the ON/OFF
key on your remote; you will hear 3 more beeps
to acknowledge successful remote syncing.
5.
Press the ON/OFF key again to turn off the
remote. The remote is now ready to use.
MAIN
BURNER
SWITCH
Power Vent (PV) Switch
For convenience, the fireplace comes pre-wired for
power vent applications. If needed, to switch into
power vent (PV) mode locate the PV switch next to
the Remote Sync Button. The far left rocker switch
with the cover above it controls the mode setting of
the fireplace's IFC. From the factory the
-
symbol is
down, press the rocker switch so that the
O
symbol is
down. To clarify:
-
Symbol down = Direct Vent (DV) mode
O
symbol down = Power Vent (PV) mode
If for some reason the IFC needs to be switched back
to DV mode simply press the switch again
with main
power disconnected
.
IMPORTANT
- Main power
must not
be connected
to the fireplace prior to switching between DV
and PV modes. If power is connected the IFC will
remain in the previous mode until power is removed.
Turning the fireplace on and off via the remote will
not correct this.
Quick Tip - A typical symptom of the fireplace being
inadvertently switched to PV mode is a responsive
remote with full control of the Light and AUX circuits
but no pilot ignition sequence.
Maintenance and Service