© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
4
4.
ASSEMBLY INSTRUCTIONS
A.
Fully separate the Crossbar ends (parts 4), you will find the Crossbar rails (parts 5) inside.
fig. 2
fig. 3
4
1
4
7
4
4
5
13
13
C.
Line up the 4 holes on the Side brackets (part 6)
with the two of the Crossbar end and leg assemblies
from the previous step.
Insert qty four (4) M6x14 Machine screws (part 13) through
the 4 holes of the each Side bracket (part 6) going into
the Crossbar end/Leg assembly. Using the Allen wrench,
rotate each screw ONLY 3 times.
4
6
13
D.
Once all of the parts are connected, you can now tighten the twelve (12) Screws from Step B
and the eight (8) Machine screws from Step C (20 screws in total).
7
E.
Remove backing from the Adhesive pads
(part 8) and position along the brackets and
frames as shown.
B.
Position the Crossbar ends (part 4) on their sides. You will be inserting
the Legs (part 1) into the Crossbar ends (parts 4) from below. When positioned
correctly, the mount tabs will be facing up (fig. 1).
Now, place the Legs (part 1) into the Crossbar ends (part 4) and Zero crossbar
bracket (part 7) from the bottom (fig. 2).
fig. 1
Line up the holes on each leg with the holes on each Crossbar end and the Zero crossbar bracket.
Using the supplied Allen wrench, insert twelve (12) M6x14 Machine screws (part 13) to connect them all,
and
rotate each screw only a few turns
. Do not tighten fully until step D.
7
