© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
6
9
L.
Use two (2) of the #10x5/8’’ Wood
screws (part 16) to attach the Control box
(part 9). Ensure enough clearance at the
wire ports for cable connections. For ease of
installation use the pre-drilled hole locations.
Place the Keypad (part 10) at the pre-drilled
hole locations, and attach using two (2) of
the #10x5/8’’ Wood Screws (part 16).
Note:
Do not over-tighten the
screws, it may break the plastic
10
M.
With two people, grab the desk by the base and the desktop, to sup-
port them both equally, and turn the desk right-side up. If necessary, adjust
the Levelling studs (part 11) underneath each foot to level out your desk.
N.
Plug the Power Cord into a 110v outlet.
IMPORTANT!
You must RESET the desk prior to use!
Press and hold the DOWN button on the Keypad until the desk reaches
its lowest height. Release the DOWN button. Press and hold the DOWN
button again until the LED display reads “RST” or about 10 seconds on
non-LED handset models. Release the DOWN button. Press and hold
the DOWN button again until the desk lowers a little bit more, slightly
rises and stops. Release the DOWN button. Your desk is now ready to use.
To program up to four presets:
Use the up/down buttons to find a desired height, then press “M” followed by a number 1 – 4.
10
T.
Connect the Legs and Keypad to the Control box
with the Cables (part 12). You will find that they all hang
loose. Once everything is connected, use the Cable clips
(part 17) to keep them snug up against the desktop, to pre-
vent them from getting caught on things under your desk.
17
12
