© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
7
5.
DESK PLACEMENT
Following desk assembly, adjust the pre-installed Leveling studs (part 13) or casters (sold separately) on
the feet so that the desk is level and does not shift its position.
When moving the desk, if casters are not installed, use two people to lift the desk so that it can be moved
without dragging. Dragging the desk may cause the frame and screws to pull loose from the desktop.
When moving the desk, DO NOT lift the desk by the desktop alone, or the frame alone. Support both the
frame and the desktop equally. Favoring one over the other can stress the fasteners connecting the desk
frame to the desktop. Lower the desk completely and lift the desk by grasping the frame.
Choose a placement for the desk that’s a safe distance from window frames, radiators, furniture, etc., so
that people do not get stuck or trapped by the desk.
Check cord clearance, so that they don’t get jammed. Then connect the desk to the 120v outlet and the
desk is ready for use.
Do not place any objects underneath the desk that are taller than 20’’.
6. PROGRAMMING:
If you’ve purchased an UPLIFT Desk and the Advanced 1-touch digital keypad, press the DOWN button
on the Keypad until the frame reaches its lowest position. Measure the height of the frame from the floor
to the underside of the desktop and if the number on the LED display does NOT match your measure-
ment, follow these steps:
Press and hold the DOWN button again until the LED display reads “RST”
Press and hold the “M” button (about 5 seconds) until the LED displays the flashing starting height.
(If the display returns to “RST” before the next step is taken, repeat this step.)
To change the value of the starting height:
By 0.1s:
Increase: press the UP button
Decrease: press the DOWN button
Once the new value is displayed, wait about 5 seconds and the display will return to “RST”. Finish
the reset process by pressing and holding the DOWN button again until the desk lowers a little bit
more, slightly rises and stops. Release the DOWN button. The new starting height value is saved
and your desk is now ready to use.
Note: the LED display has a 0.1 tolerance.
+-
By 1.0s:
Increase: press the “l” button
Decrease: press the “2” button
By 10.0s:
Increase: press the “3” button
Decrease: press the “4” button
SETTING THE LED RETRACTED HEIGHT
