© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
4
B.
Position the Crossbar ends (part 3) on their sides. You will be inserting
the Legs (part 1) into the Crossbar ends (parts 3) from below. When positioned
correctly, the mount tabs will be facing up (fig. 1).
Now, place the Legs (part 1) into the Crossbar
ends (part 3) into the bottom (fig. 2).
fig. 1
3
5
11
C.
Using the supplied Allen wrench, insert four (4) M6x14
Machine screws (part 11) into the Crossbar ends, and
rotate
each screw only a few turns
. Do not tighten fully until step D.
If you drop a screw inside the Crossbar end, simply tilt
to retrieve the screw.
4.
ASSEMBLY INSTRUCTIONS
A.
Fully separate the Crossbar ends (part 3) you will find the Crossbar rails (parts 4) inside.
3
3
4
4
D.
Take the two Side brackets (part 5) and attach them to the Leg
assemblies, using four (4) M6x14 Machine screws (part 11) each. Use
the Allen wrench, and
rotate each screw only a few turns.
Do not
tighten fully until step D.
If you are having trouble getting all the screws started, it is because
other screws are too tight. You’ll need to back out some screws in
order to loosen the tolerance of the screw holes.
E.
Once all of the parts are connected, you can now tighten the eight (8) Screws from Step B and the
eight (8) Screws from Step C (16 screws in total).
F.
Remove backing from the Adhesive pads (part 6) and position
along the assembly as shown. Be sure to not cover any of the holes.
11
11
fig. 2
1
1
3
3
3
