© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
5
H.
Your UPLIFT Eco desktop is pre-drilled with threaded
inserts. Place the desktop on the ground, with the pre-drilled
holes facing up, and carefully place the upside down desk base
on the underside of the desktop.
Adjust the width of the base so that the holes in the
bracket line up with the pre-drilled holes in the desktop.
I.
Ensure that the base is lined up with the threaded
inserts in the underside of the desktop. Double check that
the screws you’re using are the correct ones; you need to
be using the #10-1/2’’ Machine screw (part 13).
Install as follows:
3 per Side bracket
6 total
1 per Crossbar end
2 total
J.
Secure the Crossbar Rails at both ends using M6x10
Machine screws (part 12), qty 4 per side.
Ensure that the machine screw hits the metal center rail
by sliding the center rail as needed.
13
12
F.
Slide Crossbar rails (part 4) back into Crossbar ends (part 3).
Make sure that the Crossbar rail (part 4) can slide all the way to
the end of the Crossbar end (part 3).
If it doesn’t fit, take the Crossbar rail out and flip it over, with the
slots facing inward.
4
3
3
G.
Attach each Foot (part 2) with four (4)
M6x14 Machine screws (part 11) and tighten
bolts in a cross pattern.
2
2
1
1
11
