© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
6
9
L.
Turn the assembled desk right-side up. With two people, grab the
desk by the frame and desktop equally, and turn the desk right-side up.
Note:
Make sure no obstacles are in the desk’s path. Make sure cords
are a length that will accommodate the change in height.
If necessary, adjust the levelling studs underneith each foot
to level out your desk.
14
K.
Place the Keypad (part 8) so that its front runs flush
with the desktop edge (or recessed up to 1/8”). It can be
placed anywhere along the front edge of the desk, but we
recommend placing it near a side so it won’t interfere with
your chair or legs when seated. Use the pre-drilled hole
locations, or place where preferred.
Use the #10x5/8 Wood Screws (part 14) to attach the
Keypad (part 8) and the Control box (part 7) to the
desktop.
Note:
Do not over-tighten the screws, or else you
may break the plastic.
8
7
14
K.
Place the Control box (part 7) and ensure enough
clearance at the wire ports for cable connections.
Use the pre-drilled hole locations, or place where
preferred.
Use the #10x5/8 Wood Screws (part 14) to attach
the Keypad (part 8) and the Control box (part 7)
to the desktop.
Note:
Do not over-tighten the screws, or else
you may break the plastic.
M.
Connect the legs and keypad to the Control box with
the Cables (part 14). You will find that they all hang loose.
Once everything is connected, use the Cable clips (part 22)
to keep them snug up against the desktop, to prevent them
from getting caught on things under your desk.
15
10
