Industrial/EasyLAN 100i Interface Kit for XP – Installation Instructions Ed. 1
4
Chapter 2
This description applies to Intermec EasyCoder 501 XP and
Intermec EasyCoder 601 XP. Illustrations show an EasyCoder
501 XP.
Warning!
The electronics compartment contains high voltage compo-
nents and wires. Do not open the electronics compartment
before the printer is switched off and safely disconnected
from any AC supply.
• Open the right-hand door.
• Remove the four #T10 Torx screws along the lower edge of
the cover over the electronics compartment.
• Remove the four #T10 Torx screws that hold the upper edge
of the same cover.
• Remove the cover and put it aside on a soft cloth or similar
to avoid scratches.
2. Installation
Step-by-Step Instruc-
tions
#T10 Torx screws (4x)
#T10 Torx screws (4x)
