Universal Laser Systems Industrial ILS12.150D, Инструкция по установке и настройке

Страница: 31 / 36

Running Your First Job
31
Step 4 – Starting the Process
Turn on the exhaust and ILS system. 1.
Note: Laser system cooling fans are variable speed and may speed up and slow down during
operation as needed to cool the lasers.
Make sure the material is positioned correctly within the engraving area. 2.
Close the top door. 3.
Click the green START button on the UCP to begin laser processing (Figure 6 on previous page). 4.
CAUTION:
Observe that the laser system is functioning as desired. If any abnormalities occur,
including, but not limited to, flaming, sparking, melting or excessive smoking of the material you
are engraving, STOP THE ENGRAVING PROCESS IMMEDIATELY BY EITHER PRESSING THE PAUSE
BUTTON OR OPENING THE TOP DOOR. Re-check the settings in the printer driver as well as the laser
system. If everything seems to be correct, check focus manually as described in the User Manual
located in the Reference Guide packet and adjust if necessary. If you cannot resolve the issue, please
contact your distributor or the ULS Customer Service Team. NEVER LEAVE THE LASER SYSTEM
UNATTENDED DURING THE ENGRAVING OR CUTTING PROCESS.
Step 5 – Material Removal and Reloading
Once the laser system has completed processing the material, the laser beam will turn off and the focus
carriage will move to the home position in the upper right hand corner.
Before opening the top door, wait a few seconds to allow any remaining fumes that are leftover from the
laser engraving or cutting process to evacuate through the exhaust system.
Congratulations! You have just completed your first engraving project with your new ILS system.
Below is an image of the sample engraving job. If your results are not satisfactory, please contact
the Customer Service Department at 480-609-0297 (USA), +43 1 402 22 50 (Austria), +81 (45)
224-2270 (Japan) or e-mail us at support@ulsinc.com.