Universal Laser Systems Industrial ILS12.150D, Инструкция по установке и настройке

Страница: 23 / 36

Assembling Your ILS System
23
If one or more of the other corners does not match the upper left corner, adjust the caster 11.
directly underneath that corner up or down until the focus tool fit at that corner matches the fit
at the upper left corner. First loosen the lock nut (1), then turn the adjusting screw (2) in 1/8
turns. Once the foot is at the correct height, tighten the lock nut (1). When you are done, the
focus tool fit at all four corners should be the same.
Once properly leveled, 12. proceed to page 24.
*Alternate leveling method
For the best leveling results, use a digital caliper and adjust the caster directly under each corner that
does not match the height of the upper left corner until that corner matches the upper left corner’s
height. Verify that you zero out the caliper before taking any measurements. The height at each corner
should be within 0.010” (0.254 mm) of the height at the upper left corner.