UNITED CPC4000, Руководство по эксплуатации и обслуживанию

Страница: 18 / 39

©United Surface Solutions • 11901 Burke St, Santa Fe Springs, CA 90670 • (877) 837-4623 • deburring.com
Will Not Begin Cycle
Possible Problem Item to Check Remarks
No power to the machine Verify that the Power Indicator is lit
and the CPC screen is operational. Follow the procedures under
“Interface Not Functioning”
Shutter Door is not closed
entirely The Shutter Door must be closed in
order in order to place the machine
in Run Mode. Always either completely open or
completely close the Shutter Door.
Drive error Check Drive Keypad for error code. Refer to the instruction manual for
the drive that was supplied with the
machine or contact AXYS for
support.
Loose wire or defective
component Turn the main disconnect to the
“Off” position and carefully check
and retighten electrical connections
beginning at the main disconnect. If you are certified to work with high
voltage AC, re-energize the
Disconnect and follow the voltage
paths until you find the problem.
Premature System Halt
Possible Problem Item to Check Remarks
No power to the machine Verify that the Power Indicator is lit Follow the procedures under
“Interface Not Functioning”
Drive error or overload Check Drive Keypad for error code. Refer to the instruction manual for
the drive that was supplied with the
machine or contact AXYS for
support.
Human error Attempting to open the Shutter
Door while the machine is running
may result in the cycle being
canceled.
The Stop Button may have been
accidentally pressed.
If the cycle timer has reset, human
error is likely the problem. If the
machine is stopped and the timer is
still running, human error must be
discounted.
E-Stop activated Check the CPC Touch Screen to
determine if the E-Stop has been
activated. If the E-Stop has been activated the
timer will display the remaining time.
Proceed to Manual Mode Screen to
determine time remaining and finish
the current process.
Loose wire or defective
component Turn the main disconnect to the
“Off” position and carefully check
and retighten electrical connections
beginning at the main disconnect. If you are certified to work with high
voltage AC, re-energize the
Disconnect and follow the voltage
paths until you find the problem.