UNITED CPC4000, Руководство по эксплуатации и обслуживанию

Страница: 12 / 39

©United Surface Solutions • 11901 Burke St, Santa Fe Springs, CA 90670 • (877) 837-4623 • deburring.com
The RPM & Time screen is one of the most important screens in process
storage and is required to save a process. This screen directly controls
machine settings when running a process. Tap on each empty field to
enter the recommended time and RPM. Press ENT after entering each
value. These values are only for the first (or only) step. Press RETURN when
done to review the process.
The process screen has options to press > to add a 2
nd
step, turn auto
reverse on (reverses the rotation of the turret at the halfway point in a
process), or press RETURN to complete the
process storage. If there are any errors, you may
correct them by pressing on them. You will be
notified if the RPM & Time are missing. You will
be returned to the Process List screen.
3.3.2 Running a Process
Loading Barrels
To run a process, choose a process from the Process List screen and press
RUN. The Loading Instructions screen will appear. Use these instructions to
load each barrel with the correct amount of compound, water, media, and
parts.
To load a barrel, first remove it from the cradle. Do this by pulling the pin,
rotating the lockbar, and pulling it out. To open a barrel, rotate and
remove its lockbar. Then remove the lid. Load it starting with media and
parts, then water, and finally compound. Replace the lid and lock it in place with the lockbar.
Beginning Process
To begin a process, press CONTINUE from the Loading Instructions screen.
To jog the turret, hold the button and press JOG FWD or JOG REV on the
Automatic Operation screen. Before beginning operation, ensure all
information on the screen is correct. If starting a process from the
beginning, ensure the CYCLE TIME REMAINING matches the CYCLE TIME. If
it does not, press
R to reset it. To start the cycle, press PRESS TO START.
Stopping a Process
To stop a process before it has been completed, press STOP (takes the place of PRESS TO START). The turret
will slow to a stop. Once stopped, the door will unlock and may be opened. The cycle time remaining will be
saved on the Automatic Operation screen. The process can be continued by pressing PRESS TO START. If the
process will not continue, remove your parts and reset the cycle time.