-8-
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
-9-
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
OPERATING INSTRUCTIONS
PREPARING FOR OPERATION
1.
Extend the shell fully and lock into place as shown in the enclosed instructions sheet before lighting or operating the heater.
2.
Check the heater for possible shipping damage. If any is found, immediately notify the factory.
3.
Follow all of the safety and operating precautions.
4.
Connect the POL fitting of hose and regulator assembly to the propane cylinder by rotating the POL nut counterclockwise
into the propane cylinder’s valve outlet and securely tighten with a wrench.
5.
Connect the hose to the heater.
6.
Securely tighten all gas connections.
7.
Open the cylinder’s gas valve and check all gas connections with a soap and water solution. DO NOT USE A FLAME.
STARTING THE HF80C
1.
WARNING: BEFORE LIGHTING PILOT, turn main burner valve (turn knob fully clockwise) to low/light position.
2.
Fully open the valve on the propane cylinder and wait 15 seconds before Step 3.
3.
Push knob in and hold for 5 seconds, allowing gas to emit from burner orifice.
4.
Rotate the knob counterclockwise until the piezo igniter clicks. Continue to rotate and activate the igniter until the burner
lights.
5.
Once the burner lights hold the knob in, on the low position for 30 seconds. Then release. The burner should stay lit. If it does
not repeat steps 4 & 5 until the burner stays lit.
6.
Turn main burner valve to regulate heat output.
STARTING THE HF200C
1.
WARNING: BEFORE LIGHTING PILOT, turn main burner valve (turn knob fully clockwise) to low/light position.
2.
Fully open the valve on the propane cylinder and wait 15 seconds before Step 3.
3.
Depress red button on safety pilot valve (to the right of the variable valve knob) admitting gas to the pilot. Then push and
release the ignition button (red button to the right of the variable valve knob) until the pilot lights.
4.
When the pilot lights, continue to hold the button depressed for 30 seconds, then release to light main burner.
5.
If pilot goes out, wait 5 minutes and repeat the lighting procedure.
6.
Turn main burner valve to regulate heat output.
STOP (ALL UNITS)
1.
Securely close valve on the propane cylinder.
2.
Continue to operate heater until all fuel in the hose has burned.
3.
Turn main burner valve to lo/light position.
RESTART AFTER SAFETY SHUTDOWN
1.
Securely close valve at propane cylinder.
2. Wait 5 minutes.
3.
Restart following “Start” procedure for your model.
