United States Stove Company SP1000E, Руководство пользователя

Страница: 97 / 188

© 2023 Breckwell
11
prevent the stove from tripping the high temp thermodisc. If
the high temp thermodisc does trip, see “Safety Features.”
CAUTION:
THE “5” SETTING IS DESIGNED FOR TEMPORARY USE
ONLY. IF USED FOR EXTENDED PERIODS, IT CAN SHORTEN
THE LIFE EXPECTANCY OF THE UNITS COMPONENTS.
AVOID USE AT THIS SETTING FOR MORE THAN ONE OR
TWO HOURS AT A TIME.
OPTIONAL THERMOSTAT
An optional thermostat may help you maintain a constant
house temperature automatically. A millivolt thermostat
is required. The control panel can be set up two ways to
operate your stove in thermostat mode.
FIGURE 14
N
On/Off High/Low Manual
Connect
Thermostat
Wires Here
On/Off High/Low Manual
THERMOSTAT INSTALLATION
• A MILLIVOLT THERMOSTAT IS REQUIRED.
• Unplug stove from power outlet.
• Remove control board from stove.
• The two thermostat wires connect to the terminal block on
the lower left side of the back of the control board.
• Insert wires in the terminal side and tighten the two screws.
MODES
TO SWITCH BETWEEN ANY OF THE THREE MODES, THE
STOVE MUST BE SHUT OFF, THE NEW MODE SELECTED
AND THE STOVE RESTARTED.
MANUAL MODE
• USE THIS MODE EXCLUSIVELY IF YOU DO NOT
CONNECT AN OPTIONAL THERMOSTAT.
• In this mode, the stove will operate only from the control
panel as detailed in the “Operation” section of this
owner’s manual.
HIGH/LOW THERMOSTAT MODE
• USE THIS MODE ONLY IF YOU CONNECT A
THERMOSTAT.
• When engaged in this mode, the stove will automatically
switch be- tween two settings. When warm enough, it will
switch to the #1 or low setting. The room air blower will
also slow to its lowest speed.
• The Heat Level Advance setting on the bar graph will stay
where it was initially set. When the home cools below the
thermostat setting, the stove will switch to the feed rate of
the heat level advance setting.
ON/OFF THERMOSTAT MODE
• USE THIS MODE ONLY OF YOU CONNECT A
THERMOSTAT
• In this mode, when the home is warm enough, the stove
will shut off. The fans will continue to run until the stove
cools.
• When the home cools below the thermostat setting, the
stove will automatically restart and run at the last feed
rate setting.
NOTE: When in “High/Low” or “On/Off” thermostat mode
• Do not operate the stove higher than the #3 setting.
• Set damper control rod approximately 1/4” (7 mm) to
1/2” (13 mm) out. This will vary depending on elevation
and weather conditions. Observe stoves operation and
adjust damper as necessary.
WARNING:
• DO NOT USE CHEMICALS OR FLUIDS TO START
THE FIRE - NEVER USE GASOLINE, GASOLINE-TYPE
LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER
FLUID, OR SIMILAR LIQUIDS TO START OR “FRESHEN
UP” A FIRE IN THIS STOVE. KEEP ALL SUCH LIQUIDS
WELL AWAY FROM THE STOVE WHILE IT IS IN USE.
• HOT WHILE IN OPERATION. KEEP CHILDREN,
CLOTHING AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS.
This heater is designed to burn only PFI Premium grade
pellets. DO NOT BURN:
OPERATION