United States Stove Company SP1000E, Руководство пользователя

Страница: 93 / 188

© 2023 Breckwell
7
12” MINIMUM
CLEARANCE
TO ROOF
VERTICAL
ROOF VENT
ATTIC
INSULATION
SHIELD
TO STOVE
3” MINUMUM
CLEARANCES TO
COMBUSTIBLES
3” MINUMUM
CLEARANCES TO
COMBUSTIBLES
VERTICALLY INTO EXISTING CHIMNEY SYSTEM
Adapters are available to adapt from 3” (77 mm) L-Vent
to 6” (153 mm) or 8” (204 mm) Class-A chimney. As an
alternative, 3” (77 mm) or 4” (102 mm) L-Vent can be run
inside existing chimney to termination. This is the preferred
method. Follow guidelines for equivalent vent length.
PELLET
VENT
NOTE:
THIS METHOD
IS PREFERRED
EXISTING
CHIMNEY
SYSTEM
PELLET VENT TO
CHIMNEY ADAPTER
(SPV-CA)
UNIVERSAL
CONNECTOR
EXISTING
CHIMNEY
SYSTEM
VERTICALLY INTO EXISTING MASONRY
FIREPLACE
1. Have the masonry chimney inspected by a qualified
chimney sweep or installer to determine its structural
condition.
2. You will need a pipe length equal to the chimney height
from the hearth. If outside combustion air is to be used,
you will need a pipe length equal to the chimney height
plus 18” (458 mm).
3. Install a blanking plate and the chimney pipe, and if
used the outside air pipe, as shown.
4. Attach the L-Vent adapter, a section of pipe and clean-
out tee, making sure the clean-out tee is centered in
the chimney flue area. Use RTV, metallic tape, and
a minimum of three self-taping screw at all joint
connections to ensure a tight seal.
5. Position the stove, adhering to the clearances.
6. Measure and build chimney top plate. Cut out holes for
chimney pipe, and if used the outside air pipe. Install
and seal with non-hardening mastic to prevent water
leakage. Install vent cap.
6”
(153 mm)
6”
(153 mm)
3”
(77 mm)
NOTE: FOLLOW
METAL CHIMNEY
INSTALLATION
INSTRUCTIONS
TOP PLATE (SEAL
TO CHIMNEY TOP
WITH NON-
HARDENING
MASTIC)
EXTENSION TO
CHIMNEY TOP
REQUIRED.
3” OR 4” STAINLESS
STEEL SINGLE WALL
PIPE OR FLEX PIPE.
BLANKING PLATE
(SEAL WITH NON-
HARDENING MASTIC).
3” OR 4” STAINLESS
STEEL FLEX PIPE.
OPTIONAL OUTSIDE AIR
CLEAN-OUT-TEE (TYPE L)
OR 90 DEGREE ELBOW
HEARTH
THROUGH SIDE OF MASONRY CHIMNEY
1. Position the stove, adhering to the clearances. Mark
the center of the hole where the pipe is to pierce the
masonry chimney.
2. It will be necessary to break out the masonry around
the location of the pipe center mark. Use a 4” (102
mm) diameter hole for 3” (77 mm) pipe and 5” (127
mm) diameter hole for 4” (102 mm) pipe.
3. Measure and build chimney top plate. Cut out holes for
chimney pipe, and if used, the outside air pipe.
4. Install the tee on the bottom of the vertical pipe system
and lower it down the chimney until the center branch
of the tee is level with the center of the hole in the
masonry as shown.
5. Install and seal the top plate from step 3 with non-
INSTALLATION