5
IP 20001
2.
The harness can also be found in Figure 3. The harness can be routed as need for a
given application. Holes for wire tying the harness can be seen in Figure 3.
Figure 3 – WIRE TIE LOCATIONS
3.
Depending on the unit that is being installed, it will be required to connect the CAPS‐
Commuter unit to either 120VAC or 12VDC power supply. The power source that the
unit is connected to should be switched by the ignition or something similar. This will
prevent the system from being left on accidentally, causing the vehicle battery to die.
Use external wiring grommet circled in Figure 3 if the wiring is being routed externally,
grommet not used if routed internally.
4.
To power the unit on after power has been connected to it, us the push button switch
that can be found on the side of the unit (Figure 4). With the button depressed the unit
will be off. With the button pressed, the light with internal fan will be on.
