United Process Controls PROTHERM 50, Руководство по эксплуатации

Страница: 18 / 28

UNITED PROCESS CONTROLS GMBH Page 17 Protherm 50 P68.230
CAN-Bus
Attention! Changes in this menu become effective not until the PT50 is switched off and on
PT50 is equipped with a CAN-Bus-Interface as standard. Two operating modes are available:
1. CANBUS Slave: The module corresponds to the CANopen-Standard (implements not yet completely)
2. CANBUS Standalone: The module works as masters for I/O modules according the CANopen-
Standard and sends when switching on " Node start” commands.
In operating mode „Standalone “ the connection between PT50 and the I/O-modules are watched by
nodeguarding ( WA)
Further information about the operation of the PT50 with CAN-Bus-Interface is available in a separate
document.
Baud rate
Baud rate of the CAN-connection
NodeID
CANopen-NodeID of the PT50
IO-MODUL ID
CANopen-NodeID of the I/O-modul in Standalone-mode. If 0, then the module is not spoken to.
CATSENSOR ID
CANopen-NodeID of an additional Catsensors with Standalone-operation. If 0, then the module will be
not addressed.
Autosend
Reserved for future enhancements. Must be set always to 0.
Operating mode
Selection of CANBUS Slave / Standalone