8
© 2016 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
MS912+ User’s Manual
b. Refer to the numeric barcode table on
Appendix A
and scan the
same numbers that you used as the pin code on your Host device.
For example, if your pin code is “241657”, scan [2] – [4] – [1] – [6] –
[5] – [7] in sequential order.
c.
Scan the [Enter] barcode below:
Enter
d. Scan the [Pincode-Stop] barcode:
Pincode-Stop
10. On your Host device you will see the message under [Wireless Scanner]
saying [connecting...].
11. Once that message turns to [Paired and Connected], the scanner will beep
twice to verify a successful connection, and you are ready to start scanning
bar code date into your Host device.
a. To do a test, open up Word or Note Pad or even a new E-mail
[anything that will allow you to type in data].
b. Scan a number bar code from this manual.
c.
That number should appear on your Host device in the application
you opened.
d. If not, please scan [Disconnect] barcode below and repeat steps 1 to
9 above.
Note: To disconnect the scanner from the host or to switch the wireless profile
from one to another,please scan the [Disconnect] barcode:
Disconnect
After scanning the [Disconnect] barcode, the MS912+ will emit 3 beeps..
