Unisys Aquanta CP Series, Руководство по настройке

Страница: 31 / 89

Upgrading Your System
3814 9779-000 1–19
Adding Drives
Your system unit supports up to three drives: a 3.5-inch, 1.44MB (3-mode) floppy
drive; a 3.5-inch, one-third height, internal hard drive; and a “slim ” CD -ROM drive
with a 56-pin ATAPI cable.
Installing a CD-ROM Drive
1. Turn the system off. Disconnect the power cord and all peripherals.
2. Remove the system unit cover, as described earlier in this section.
Caution
Protect your system from ESD, as described in “Avoiding Electrostatic
Discharge,” earlier in this section.
3. Remove the plastic drive bay cover from the front panel, as needed.
4. Remove and discard the metal drive bay cover from the chassis, as needed, by
bending it until the tabs flex and break free. This cover cannot be replaced.
5. Remove the front panel, as described earlier in this section.
6. Open the drive carton and remove the drive.
7. Insert the drive into the 5.25-inch drive bay, as shown in Figure 1–8.
8. Secure the drive with the three screws provided.
9. Connect the 56-pin ATAPI cable to the slim CD-ROM drive and the secondary
IDE connector on the motherboard.
10. Replace the front panel, as described earlier in this section.